Are You Using a Spring Push System?

There's only one power supply that is powering the board and is connected through the line. I think you're not supposed to run more than one solenoid at a time. But I have made that mistake of opening up too many relays. And then once I activate that relay, closes it since the 24 volts down to that solenoid, it comes on. They require constant power to stay open. So if powers cut, they'll close. That's also a safety measure in terms of like if the power runs out, like if you lose power in the middle of a water cycle, then this sprinkles all shut off. Yeah. Well, it's nice to have a

Transcript

Play full episode

Remember Everything You Learn from Podcasts

Save insights instantly, chat with episodes, and build lasting knowledge - all powered by AI.