Using Brass to Sodder Joints

It's actually a lot easier than it looksa, as far as getting the precise angles. You take a print out of a true scale template, and then you use that as a reference as your bending and cutting his brass. So everything starts in a twiy two dimensional plane, andThen you start putting those together to form a three-dimensional sculpture. When you sotter things together, you hadd you put them on the paper. Do you just tape them? Yes. And then when you sotters one thing, yo, not unsolder, the previous joint. That can be tricky if two sodder joints are very close to one another, because the heat yet